Panasonic WJND400 - NETWORK DISK RECORDER, Operating Instructions Manual

Page: 84 / 233

Major Operatin g Controls and Their Functions
15
(1) Handle for Maintenance
Loosen the 5 scre w s indicated b y the triangles and grip these
handles to pull off the panel w hen replacing the fan or doing
other maintenance w ork.
(2) Alarm/Control connector [ALARM/
CONTROL], D-Sub 25 pin
Use to connect alarm devices ( b uzzers or indicators),
external devices, control s w itches controlled b y the recorder.
(3) Alarm connector [ALARM], D-sub 25 pin
Use to connect alarm-related devices such as a sensor or a
door s
w itch.
(4) Cable clamp fixin g holes
Install the ca b le clamp (provided w ith the extension unit) to
secure the connection ca b les.
For details refer to the manual for the extension unit ( W J-
HDE400).
(5) External stora g e connector [EXT STORAGE]
Use to connect the ( W J-HDE400) extension unit and the
recorder w ith the connection ca b le (provided w ith the
extension unit).
(6) Client PC port [PC]
Use to connect a PC, 10BASE-T, 100BASE-TX, or
1000BASE-T net
w ork.
(7) Camera port [CAMERA]
Use to connect a camera, 10BASE-T, 100BASE-TX, or
1000BASE-T net
w ork.
(8) Si g nal GND terminal [SIGNAL GND]
Use as a ground w hen the recorder ' s Signal GND terminal is
connected to another device ' s Signal GND terminal. Static or
other noise related pro b lems may occur if a ground is not
connected.
(9) Power cord Inlet [AC IN]
Connect the provided po w er cord here. The po w er plug is a
t w o prong plug w ith a ground terminal.
(10) Power switch [POWER]
Turns the po w er on. Press it again to turn the po w er off and
end operations.
Secure the po w er cord w ith the b race.
1
Lock the power cord in place by liftin g and latchin g the
brace.
Rear View
(9) (10) (8) (7) (6) (5)
(1)(2) (3) (1) (4)
Usin g the Brace
Brace
ND400_Basic.book 15 ページ ２００８年７月１０日 木曜日 午前１０時５０分