46
Note: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding
function and the function should be set to enabled.
You cannot change the port settings when “Use UPnP” is On.
Highlight the “Status” box and press the button to display the port numbers forwarded from the NAT device
via UPnP service.
Highlight the “Test” box and press the button to test the current LAN settings you made.
Figure 51: Network – LAN (DHCP) screen
Selecting “DHCP” from the Type and highlighting “Save” button reads the current IP address of the recorder
configured by DHCP (Dynamic Host Configuration Protocol) network.
Highlight “Auto” (Default) and press the button to toggle between On and Off. When it is On, the recorder
will obtain the IP address of the DNS server automatically.
Note: Selecting “Auto” will only be enabled when the recorder is configured for DHCP.
If the recorder is configured for DHCP, the IP address of the recorder might change whenever
the unit is turned on.
FEN
Figure 52: Network – FEN setup screen
Highlight “Use FEN” and press the button to toggle between On and Off.
