20
■
RECEIVE A CALL?
NO.
◆◆◆
◆◆◆◆◆◆◆◆◆◆
YES NO
←→
:SELECT ENT:EXEC DIAL:YES ESC:NO
01/01/99 17:13:05
ALARM2
●●
TITLE
ALARM DIAL 01/01/99 17:12:30 NO.2
There are two ways of receiving calls: Automatic and man-
ual.
If automatic receiving mode has been set, then incoming
calls are automatically received by the AV Codec.
The operating procedures described below apply in cases
where the manual receiving mode has been set.
If Calling Number Check is set to ON in the system
setup process, then the telephone numbers of incom-
ing calls are checked. They are only connected if they
are registered in the directory.
Those telephone numbers not registered in the directo-
ry or not reported are automatically rejected.
Note
1
When there is an incoming call, the following screen appears
on the monitor (when receiving manually).
2
Press the DIAL button to allow connection.
• Communication starts when the
DIAL
button is pressed. The video sent
from the calling site is displayed on the monitor. If audio is sent, it is also
output.
• To reject the incoming call, press the
ESC
button.
Incoming calls can also be allowed or rejected by selecting [YES] or [NO]
with the Direction buttons and pressing the
ENTER
button.
In case of an alarm dialing call, the ALARM DIAL display appears on the
monitor screen as shown below.
• If the number is registered in the directory, then the quick dial
number and destination title are shown.
• If it is not registered, then the telephone number is shown.
STEP2
STEP3
DIAL
MEMORY
CALL
REDIAL
DELETE
ESC
AUDIO MUTE
MENU
ALM MEMORY
ENTER
TELE
WIDE
AF
NEAR
FAR
STEP1
Remote Controller WV-CU20
1
2
3
4
5
6
7
8
0
9
1
2
3
4
5
#
VIDEO
AUTO/MANU
ALM ACK
ONE TOUCH DIAL
2
The ringer sounds to indicate an
incoming call. The volume of the
ringer can be adjusted with the
ringer volume control knob. To
disable the ringer, set RINGER
on the RECEIVING REGI. setup
menu to OFF.
Note
4
3
RECEIVING OPERATION DIAL-UP STANDBY
