166
UF-7300/7200
UF-8300/8200
5.2.
Service Modes (For Facsimile)
Caution:
The factory default parameters are preset (country dependent) for optimum performance and in
compliance with the local telecommunication regulations/standards, and do not need to be changed.
Changing some of these parameters may cause the unit to be no longer compliant or become
inoperable.
5.2.1.
Fax Service Mode Procedure
1. To enter the Fax Service Mode
a. Press the
“Function”
and the
“7”
keys.
b. Press the
“Monitor”
key four times.
c. Press the
“* (Tone)”
key.
d. Input the ID, and press the
“Set”
key to enter the Service Mode (default ID is
00000000
).
e. Enter the desired code number, or press the
“ ”
,
“ ”
keys.
2. To exit the Fax Service Mode
Press the
“Stop”
key.
Note:
The following buttons provide these functions in the Service Mode:
“Start”
: The new setting value is stored in the machine.
“ ”
: Scroll the function parameter number down.
“ ”
: Scroll the function parameter number up.
5.2.2.
FAX Service Mode Table
The following service modes are provided to assist you in setting operational functions of the unit and
determining the condition of the unit.
No.
Service Mode
Description
00
Not Used
01
PARAMETER SET
Allows changes to the function parameters (the home position,
etc.).
02
RAM EDIT MODE
Factory use only.
03
PRINT REPORT / LIST
Prints the Function Parameter List, Page Memory Test, Printer
Report, All Document File, Protocol Trace and Toner Order Form.
04
MODEM TEST
Generates various binary, tonal and DTMF signals, by the modem.
05
Not Used
06
RAM INITIALIZE
Initialize RAM and restore the default value of the function
parameters.
Note:
Turn the Power Switch to the
OFF
and back to the
ON
position to enable the parameter settings.
07
Not Used
08
CHECK & CALL
Allows input of information for Service Alert Report, Maintenance
Alert Report and Toner Order Form.
09
SYSTEM MAINTENANCE
Used for Firmware Update, Parameter Restore, Parameter Backup
and Sending a Received File during a fatal printer error.
10
FIRMWARE VERSION
Displays Firmware Version for SC, SC Boot, Panel, etc.
Summary of Contents for UF-8300
