67
UF-7300/7200
UF-8300/8200
3.5.6.
Formatting the SD Memory Card
To make the Master Firmware SD Card, format the Card first by following the steps below. If the Card will
be used to update the Firmware of other machines, format the Card first with the Service Mode F9-15.
Caution:
Do not remove the SD Memory Card or turn the power OFF during Formatting or while Updating the
Firmware.
Note:
The Master Firmware SD Card can be installed or removed without turning the power OFF, however,
an SD Memory Card formatted for DATA requires the power to be cycled OFF and ON after its
installation or removal.
1) When a DATA SD Card is Not installed
1. Disconnect the Telephone Line, LAN and/or USB Cables.
2. Unplug the AC Power Cord to turn off power. (During a Lightning Storm, to prevent electrocution
disconnect the Telephone Line Cable first before unplugging the AC Power Cord.)
3. Install the SD Card into the machine.
4. Plug the AC Power Cord to turn on power.
5. Press the
“Function”
,
“Original Size”
, and the
“3”
keys sequentially.
6. Input the ID, and press the
“Set”
key to enter the Service Mode (default ID is
00000000
).
7. Select the Service Mode “F9-15 (SD Card Format)”.
8. Perform the Service Mode F9-15 (SD Card Format).
9. After the SD Card is formatted, the machine goes to Service Mode F9.
10. Press the
“Stop”
key first and press the
“Function”
,
“Clear”
keys sequentially to exit the Service
Mode.
11. Unplug the AC Power Cord to turn off power.
12. Remove the SD Memory Card from the machine.
13. Plug the AC Power Cord to turn on power.
14. Reconnect the Telephone Line, LAN and/or USB Cables.
Note:
Repeat steps 7. to 12. to continue formatting other SD Card(s).
2) When a DATA SD Card is installed
1. Disconnect the Telephone Line, LAN and/or USB Cables.
2. Unplug the AC Power Cord to turn off power. (During a Lightning Storm, to prevent electrocution
disconnect the Telephone Line Cable first before unplugging the AC Power Cord.)
3. Remove the
DATA SD Card
from the machine.
4. Install the SD Card into the machine.
5. Plug the AC Power Cord to turn on power.
6. Press the
“Function”
,
“Original Size”
, and the
“3”
keys sequentially.
7. Input the ID, and press the
“Set”
key to enter the Service Mode (default ID is
00000000
).
8. Select the Service Mode “F9-15 (SD Card Format)”.
9. Perform the Service Mode F9-15 (SD Card Format).
10. After the SD Card is formatted, the machine goes to Service Mode F9.
11. Press the
“Stop”
key first and press the
“Function”
,
“Clear”
keys sequentially to exit the Service
Mode.
12. Unplug the AC Power Cord to turn off power.
13. Remove the SD Memory Card from the machine.
14. Reinstall the
DATA SD Card
into the machine.
15. Plug the AC Power Cord to turn on power.
16. Reconnect the Telephone Line, LAN and/or USB Cables.
Note:
Repeat steps 8. to 13. to continue formatting other SD Card(s).
Summary of Contents for UF-8300
