Panasonic UF-8300, Service Manual

Page: 160 / 261

160
UF-7300/7200
UF-8300/8200
5.1.5. F6 Mode: Adjust Parameters (For Copier)
Set the machine to Service Mode, and press the “6” key.
↓
Press the “Start” key to enter the F6 Service Mode.
↓
Enter the desired code number, or press the “ ” , “ ” keys.
If you wish to select another code number, press the “ ” , “ ” keys.
↓
Press the “Set” key.
↓
Enter the desired function code number and press the “Set” key.
When the “Clear” key is pressed, the selected code input will not be accepted.
↓
Press the “Stop” key.
↓
Press the “Function” and the “Clear” keys sequentially to exit the service mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s).
Note:
1. The Factory Setting is different for each model.
2. To change the input value +/-, press the
“ ” , “ ” keys.
3. The machine may accept a (+/-) input value that exceeds the specified Setting Range for the
parameters in the table; however, the actual registered value will not exceed the Upper/Lower
Limitation value.
F6 Mode
No. Item Remarks
Setting
Range
00~03 Not Used
04 PRINTER REGISTRATION Delay time is adjusted from registration roller
clutch ON timing. -50 ~ +16
0.5mm
05~06 Not Used
07 REGISTRATION VOID Lead Edge Void can be adjusted. 0 ~ +99
0.5mm
08 Not Used
09 TRAIL EDGE PRT TIM. Adjustment of trail edge void. -9 ~ +15
0.5mm
10 Not Used
11 SIDE ADJUST (TRAY 1) Adjustment of LSU side-side (1st Tray). -8 ~ +7
0.5mm
12 SIDE ADJUST (TRAY 2) Adjustment of LSU side-side (2nd Tray). -8 ~ +7
0.5mm
13~38 Not Used
39 LSU UNIT PWM ADJUST Adjustment of PWM value of LSU. -32 ~ +32
40 TRANS CURRENT Adjustment of Transfer Current. -77 ~ +76
0.15uA
41~43 Not Used
44 FAX LASER DUTY ADJ. Printer Density Adjustment for FAX.
(-) : Darker.
(+) : Lighter.
-99 ~ +99
45 Not Used