Panasonic UF-8300, Service Manual

Page: 135 / 261

135
UF-7300/7200
UF-8300/8200
4.8. Information Code Table (For Facsimile)
Fax Information Codes
Code Mode Phase Description of Problem Cause
001 RCV
COPY
C, D Leading edge of the recording paper
fails to reach the Timing Sensor.
(1st Tray)
Recording paper jam.
Timing Sensor abnormal.
002 RCV
COPY
C, D Leading edge of the recording paper
fails to reach the Timing Sensor. (2nd
Tray)
Recording paper jam.
Timing Sensor abnormal.
007 RCV
COPY
C, D 1. Leading edge of the recording
paper fails to reach the Paper Exit
Sensor.
2. Recording paper has not
completely passed the Paper Exit
Sensor.
Recording paper jam.
Paper Exit Sensor abnormal.
008 Paper Tray is opened while paper is
feeding. Paper Tray is opened.
010 RCV
COPY
B, C No recording paper. No recording paper or paper is not set
properly.
No Paper Sensor is defective.
011 STANDBY B, C Paper Tray is not installed properly. Connector is not installed properly.
012 RCV C, D The length of the received document
is over 2 m.
Transmitter Document Jam.
017 Incorrect paper size loaded in the
Paper Tray. Paper size is incorrect.
030 XMT B Read Point Sensor does not go ON
within 10 seconds after the document
starts feeding. Document is not set properly.
Defective Read Point Sensor.
031 XMT
COPY
C Transmitting document was longer
than 2 meter (or 78.7 in). The document may jam.
Defective Read Point Sensor.
041 STANDBY
RCV
COPY
B, C,
D
Out of Toner. No toner.
Defective Low Toner Sensor.
043 STANDBY
RCV
COPY
B, C,
D
Low Toner. Toner is getting low.
Defective Low Toner Sensor.
045 STANDBY - No Toner Cartridge. Toner Cartridge has not been installed.
Defective Toner Cartridge Sensor.
060 - A Printer Cover is open. Cover is not firmly closed.
Connectors are not firmly connected.
061 - A ADF Door is open. Door is not firmly closed.
Connectors are not firmly connected.
302 XMT
RCV B, C,
D
No response of 2nd G3 PCB. 2nd G3 PCB is defective.
400 XMT B T1 timer (35 ± 5 sec.) elapsed without
detecting 300 bps signal. Incorrect number was dialed and the
START button was pushed.
Telephone line was disconnected while
dialing.
SC PCB or
MJR PCB is defective.
Receiver is defective. (It may only be
transmitting CED)