Panasonic TY-SP42PM3W, Installation Manual

Page: 32 / 59

Instruction of the installation
Fixing the wall-hanging bracket to the wall
Check the strength of the installation location
The wall-hanging bracket weighs approximately 6kg, and the display unit by
itself weighs 33kg. Refer to the wall-hanging bracket installation dimensions
in the diagram below to, check the strength of the wall in six installation locations,
and add reinforcement if any of these locations are not strong enough.
1) Select an installation site with an area of at least 1,500 mm wide by
800 mm high. Refer to the figure to make a positioning mark for the
location of the center-top hole.
2) Measure and mark the locations 450 mm to the left and 450 mm
horizontally to the right of the location you marked in 1).
3) Measure and mark the locations 450 mm below each of the marked
location.
1
Units : mm
930
490 450
50
30
20
20
450 450
100 50
15
15
Wall installation holes(6 locations)
Used for routing wires behind a wall
The wall-hanging bracket
has installation holes
provided at 24 locations.
If the wall material does
n o t a l l o w s u f f i c i e n t
strength by using six
installation holes, use
s o m e o f t h e s p a r e
holes.
However, depending on
t h e c o n s t r u c t i o n
mater ial used at the
place of installation,
cracks may develop if
the screws are inserted
too close to each other.
4-
4