Page 32
PrintCondition
193C-E-PMA01-A04-00
2. PrintScope
Input the range of printing motion of mask at printing.
When nothing is input, board is printed from edge to edge. When printing area is limited to a part of
board, input this value to adjust the range. That can improve tact time.
• When -30 is input
3. Lift
a. Clearance
It is used to adjust the opening between mask and board.
b. DWSpeed
It is used to adjust the mask releasing speed required for the stability of mask releasing.
c. DWStroke
It is used to adjust the mask releasing distance required for the stability of mask releasing.
d. ChangeLeaveSpeed
Choose the lowering speed from among the following three modes.
Const .... The support block lowers the DWStroke distance with uniform velocity.
Accel ..... The speed of the support block accelerates slowly from slower speed, and eventually it
reaches DWSpeed.
Multi ...... The speed of the support block accelerates slowly from slower speed, and eventually it
reaches DWSpeed.
∗
When the mask releasing performance is bad due to narrow pitch, etc., choose Accel mode. But
the cycle time is longer than Const mode.
When the mask releasing performance is bad even in Accel mode, choose Multi mode. But the
cycle time is longer than Accel mode.
30
30
30
30
193C-044E
193C-043E
DWSpeed
Const mode
(Input value)
Accel mode
(Input value)
Multi mode
(Input value)
DWStroke (Input value)
DWStroke (Input value)
DWStroke (Input value)
(Final velocity)
(Initial velocity)
(Final velocity)
(Initial velocity)
DWSpeed
DWSpeed
Summary of Contents for SP22P
Page 2: ......
Page 6: ...6 MEMO 193C E PMC00 B02 00...
Page 10: ...MEMO Page 4 193C E PMA00 B03 00...
Page 14: ...Page 4 193C E PMA01 A01 01 MEMO...