Panasonic S-160PE1R5B, Technical Data & Service Manual

Page: 58 / 274

1 1
1-10-8
1 1
Crimp the round terminal
Shield part
Wrap it well with insulating tape
so there are no spaces.
(6) Use the standard power supply cables for Europe (such as H05RN-F or H07RN-F which conf orm to CENELEC (HAR) rating specifications) or use the ca bles
based on IEC standard. (60245 IEC57, 60245 IEC66)
WARNING
Loose wiring may cause the terminal to overheat or result in unit malfunction. A fire haza rd may also occur.
Therefore, ensure that all wiring is tightly connected.
When connecting each power wire to the terminal, follow the instructions on “How to connect wiring to the terminal” and fasten the wire
securely with the terminal screw.
For the shield part of the shielded cable, twist the end out, crimp it with a round terminal, and connect
it to the functional earthing screw.
After crimping it with a round terminal, wrap it with insulating tape so there are no spaces and adjust it
so the shield part does not touch any live parts.
CAUTION
Be sure that the shield part of the shielded cable does not touch the terminal
block or any live parts.Failure to do so may lead to electric shock or fire.
How to connect wiring to the terminal
For stranded wires
(1) Cut the wire end with cutting pliers, then strip the insulation to expose the stranded wire
about 10 mm and tightly twist the wire ends.
(2) Using a Phillips head screwdriver, remove the terminal screw(s) on the terminal board.
(3) Using a ring connector fastener or pliers, securely clamp each stripped wire end with a
ring pressure terminal.
(4) Put the removed terminal screw through the ring pressure terminal and then replace and
tighten the terminal screw using a screwdriver.
Special washer
Screw
Terminal board
Ring pressure
terminal
Wire
Ring pressure
terminal
Wire
Screw and Special
washer
Stranded wire
Strip 10 mm
Ring pressure
terminal
SM830277-00_大洋州向け R32シングル_TD&SM.indb 8 2019/02/27 11:50:40