Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 115
Note
f
The luminance may not be detected correctly when an object is placed on top of the projector, blocking the luminance sensor. In such a
case, it may not operate properly even if [AMBIENT LIGHT DETECTION] is set to [ON].
f
When the [PROJECTOR SETUP] menu
→
[LightID] is set to [EXTERNAL CONTROL] or [INTERNAL ID], [AMBIENT LIGHT DETECTION] is
set to [OFF].
Setting [SIGNAL DETECTION]
Set if the [SIGNAL DETECTION] function to reduce the power of the light source during no signal is enabled or
not.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The
[ECO MANAGEMENT]
screen is displayed.
3) Press
as
to select [SIGNAL DETECTION].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables the [SIGNAL DETECTION] function.
[ON]
Enables the [SIGNAL DETECTION] function.
Note
f
When the [PROJECTOR SETUP] menu
→
[LightID] is set to [EXTERNAL CONTROL] or [INTERNAL ID], [SIGNAL DETECTION] is set to
[OFF].
f
The [SIGNAL DETECTION] function will also operate during MEMORY VIEWER, MIRRORING, or Panasonic APPLICATION input. In the
following cases, the projector will determine that there is no input signal.
g
MEMORY VIEWER input: USB memory is not inserted in the <VIEWER/PAIRING> terminal
g
MIRRORING input, Panasonic APPLICATION input: There is no connection from the computer, etc.
Setting [POWER MANAGEMENT]
This is a function to set the power of the projector to standby state or ready state automatically when there
is no input signal for specific time. Selection of standby state or the ready state, and the time for the power
management function to operate can be set.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The
[ECO MANAGEMENT]
screen is displayed.
3) Press
as
to select [POWER MANAGEMENT].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[SHUT DOWN]
The countdown timer is displayed when the signal input is not present for 30 seconds, and the light
source is turned off, and goes into standby after cooling when the time set in [TIMER] has elapsed.
[OFF]
Disables the power management function.
[READY]
The countdown timer is displayed when the signal input is not present for 30 seconds, and the
light source is turned off, and goes into ready state after cooling when the time set in [TIMER] has
elapsed.
The light source will turn on and starts projection when a signal is input or the button is operated while
in ready state.
f
Proceed to Step
5)
when anything other than [OFF] is selected.
5) Press the <ENTER> button.
f
The
[POWER MANAGEMENT]
screen is displayed.
6) Press
qw
to set the time for [TIMER].
f
The setting time will switch each time you press the button.
f
The time for the power management function to operate can be set from 5 minutes to 120 minutes in five-
minute interval.
