Chapter 3
Basic Operations — Operating with the remote control
ENGLISH - 77
Using the status function
Display the status of the projector.
button
1)
Press the <STATUS> button.
f
The
[STATUS]
screen is displayed.
SW1234567
10000h
10000h / 10000h
1h 23m
1/3
1.00 / 1.00
1.00
31°C/87°F
31°C/87°F
31°C/87°F
31°C/87°F
MENU
EXIT
CHANGE
ENTER
SEND E-MAIL
SELF TEST
NO ERRORS
LIGHT TEMP. 2
LIGHT TEMP. 1
EXHAUST AIR TEMP.
INTAKE AIR TEMP.
MAIN/SUB VERSION
NETWORK VERSION
LIGHT RUNTIME
CONTINUOUS LIGHTING TIME
SERIAL NUMBER
PROJECTOR RUNTIME
PROJECTOR TYPE
STATUS
PT-MZ770
Note
f
The projector status can also be displayed using the menu operation. Refer to the [PROJECTOR SETUP] menu
→
[STATUS]
(
x
page 126) for details.
Using the ECO management function
Display the setting screen relating to ECO management.
button
1)
Press the <ECO> button.
Note
f
Refer to the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT] (
x
page 114) for details.
Setting ID number of the remote control
When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using a single remote control, if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set same ID number on the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID
ALL> button on the remote control. Also, you can control a projector by pressing the <ID ALL> button on
the remote control even if you do not know the projector ID.
button
1)
Press the <ID SET> button on the remote control.
2)
Within five seconds, press and set the one‑digit or two‑digit ID number set on the projector body
using the number (<0> ‑ <9>) buttons.
f
If you press the <ID ALL> button, you can control the projectors regardless of the ID number setting of the
projector body.
Attention
f
Since the ID number of the remote control can be set without the projector body, do not press the <ID SET> button on the remote control
carelessly. If the <ID SET> button is pressed and no number (<0> - <9>) buttons are pressed within five seconds, the ID number returns to
its original value before the <ID SET> button was pressed.
