Chapter 3
Basic Operations — Switching on/off the projector
58 - ENGLISH
Power indicator
Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating
the projector.
Power indicator <ON (G)/STANDBY (R)>
Indicator status
Projector status
Off
The main power is switched off.
Red
Lit
The power is switched off. (standby mode)
Projection will start when the power <
v
/
b
> button is pressed.
f
The setting of the projector is as follows.
g
The [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[QUICK STARTUP]
is set to [OFF]
g
The [PROJECTOR SETUP] menu
→
[AUDIO SETTING]
→
[IN STANDBY MODE] is
set to [OFF]
f
The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (
x
page 196)
Blinking
The power is switched off. (standby mode)
Projection will start when the power <
v
/
b
> button is pressed.
f
The projector is set to one of the following. Power consumption is high.
g
The [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[QUICK STARTUP]
is set to [ON]
g
The [PROJECTOR SETUP] menu
→
[AUDIO SETTING]
→
[IN STANDBY MODE] is
set to [ON]
f
The indicator will change to a red light when the specified time has elapsed after the
projector enters the standby mode if the projector is set as following.
The specified time is a time set in the [PROJECTOR SETUP] menu
→
[ECO
MANAGEMENT]
→
[QUICK STARTUP]
→
[VALID PERIOD].
g
The [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[QUICK STARTUP]
is set to [ON]
g
The [PROJECTOR SETUP] menu
→
[AUDIO SETTING]
→
[IN STANDBY MODE] is
set to [OFF]
f
The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (
x
page 196)
Green
Lit
Projecting.
Orange
Lit
The projector is preparing to switch off the projector.
The power is switched off after a while. (Changes to the standby mode.)
Note
f
While the power indicator <ON (G)/STANDBY (R)> lights in orange, the fan is running to cool the projector.
f
For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks in red.
f
The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lights/blinks in red). Refer to “Power
consumption” (
x
page 219) for the power consumption.
f
The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.
f
The power indicator <ON (G)/STANDBY (R)> will blink slowly in green while the shutter function is in use (shutter: closed).