Chapter 1
Preparation — About your projector
ENGLISH - 25
Note
f
When operating the remote control by directly pointing to the remote control signal receiver at the power supply unit of the projector, operate
the remote control within a distance approximately 7 m (22'11") or shorter from the remote control signal receiver. The remote control can
control at angles of up to ±30° vertically and horizontally, but the effective control range may be reduced.
f
If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f
The signal from the remote control can be reflected off the projection surface to operate the projector. However, the operating range may be
limited from light reflection loss or the shape of the projection surface.
f
The remote control may not operate properly if the remote control signal receiver on the power supply unit of the projector is directly
receiving strong light, such as fluorescent light. Install the projector in a place distant from the light source.
Projector body
AUDIO OUT
1
4
8
7
6
2
11
1
1
9
3
14
15
16
12
2
2
2
17
18
13
10
5
Power supply unit
Main unit
1 Air intake port
2 Air exhaust port
3 Remote control signal receiver (Main unit)
4 Projection lens
5 <AC IN> terminal
Connects the power cord supplied with the optional Mount
Bracket or Floor Stand Kit.
6 Indicators (
x
pages 26, 127)
7 Remote control signal receiver (Power supply unit)
8 Power <
v
/
b
> button (
v
standby /
b
power on)
Turns on/off the power of the projector. (
x
page 39)
9 <AUDIO OUT> terminal
This is the terminal to output audio signal when a audio signal is
input to the <HDMI IN> terminal and when the movie with audio
in the SD card is played back. (
x
page 36)
10 <DC OUT> terminal cover
<DC OUT> terminal is inside. (
x
page 26)
11
Ball joint fixing screw
Fixes the angle between the shaft holder and the main unit after
adjusting the orientation of the main unit. To rotate the shaft
holder, loosen the ball joint fixing screw. (
x
page 34)
12 Ball joint stopper
To free the ball joint movable part, remove the stopper.
(
x
page 34)
13 Connecting terminals cover (
x
page 26)
The connecting terminals are inside.
14 Pole
15 Shaft holder
16 Ball joint movable part
17 Shaft
18 Ball joint
