[PROJECTOR SETUP] menu
68 - ENGLISH
Settings
[LAMP RELAY]
The lamp to be turned on can be automatically
switched by specifying the day of the week and time.
The degradation of the lamp due to continuous usage
can be reduced by automatically switching the lamp
to be turned on when using the projector continuously
for 1 week or more.
1) Press
▲▼
to select [LAMP RELAY].
2) Press
◀▶
to switch [LAMP RELAY].
▶
z
The time setting to switch the lamp will change
as follows each time you press the button.
[OFF]
[24H]
[1WEEK]
3) Press
▲▼
to select [TIME].
4) Press the <ENTER> button.
▶
z
Enters adjustment mode (the display is
blinking).
5) Press
◀▶
to select [HOUR] or
[MINUTE], and then press
▲▼
to
adjust it.
(1 hour or 1 minute increments)
[00:00]
[00:01]
[00:59]
6) Press the <ENTER> button.
▶
z
The adjusted time is established.
7) Press
▲▼
to select [DAY OF THE
WEEK].
8) Press
◀▶
to switch [DAY OF THE
WEEK].
▶
z
The setting will change as follows each time
you press the button.
[SUNDAY]
[MONDAY]
[TUESDAY]
[WEDNESDAY]
[SATURDAY]
[FRIDAY]
[THURSDAY]
Note
z
The [LAMP RELAY] function is enabled when
[DUAL] or [SINGLE] is selected in [LAMP SELECT].
z
The operating time will be the local time.(
page 73)
z
Use the number (<0> to <9>) buttons on the remote
control to directly enter the time.
[LAMP POWER]
Switch lamp brightness according to the operating
environment or purpose of the projector.
1) Press
▲▼
to select [LAMP POWER].
2) Press
◀▶
to switch [LAMP POWER].
▶
z
The setting will change as follows each time
you press the button.
[NORMAL]
[ECO]
[NORMAL]
Set when high luminance is
required.
[ECO]
Set when high luminance is not
required.
Note
z
When [ECO] is set, the power consumption and
operation sound can be reduced while the lamp life
can be increased.
[STANDBY MODE]
Set the power consumption during the standby.
1) Press
▲▼
to select [STANDBY MODE].
2) Press
◀▶
to switch [STANDBY
MODE].
▶
z
The setting will change as follows each time
you press the button.
[NORMAL]
[ECO]
Note
z
When set to [ECO], network functions and <SERIAL
OUT> terminal are not available during standby.
Also, some RS-232C commands are not available.
When set to [NORMAL], network functions and
<SERIAL OUT> terminal are available during
standby.
z
When set to [ECO], display may delay about 10
seconds when the power is turned on, compared to
the [NORMAL] setting.
