139
UF-7000/8000
APR 2007
Ver. 2.1
UF-7100/8100
4.10. Troubleshooting (For Printer)
4.10.1. Checking the Basics
4.10.2. Document Does Not Print Properly
This section explains how to solve problems including error messages, or unexpected printing results.
If the Printing System is not printing or working as expected, and if you are not sure
what to do, start your troubleshooting by checking the basics below:
• Ensure that the Ethernet LAN (10Base-T / 100Base-TX) Cable is connected properly
• Ensure that the Internet Parameters are correct
• Ensure that the Unit is turned On
• Ensure that the Paper is set properly in the Unit
• No error message is displayed on the Unit
• Try printing a test page from the printer driver properties dialog box
Problem
Possible Solution(s)
Character is not printing in the
correct positions, or the
characters near the edges of the
page are missing.
• Check, and specify the paper size and orientation settings in the printer
driver to coincide with the application.
• Check if the specified paper is loaded in the Panasonic Device.
• Increase the Page Margins in the application. The Panasonic Device
requires minimum margins of ¼ inches (5 mm) on all sides.
The font type is incorrect
• Check if the selected font is installed in the PC.
• Check if the selected font is being replaced with a proper printer font in
the Font Substitution Table of the Printer Driver Properties dialog box.
• Select ”
Always use True Type fonts
” from the
Font
tab of the Printer
Driver Properties dialog box.
The character is not smooth.
Fine line print cannot be
obtained.
• Select 600 dpi resolution.
Poor photograph print quality.
• Select 600 dpi resolution.
Different character, or symbol
from the document is printed.
• Check if the Panasonic Printing System (PCL) printer driver is selected.
The printer does not print
anything, or prints irregular
images from the middle of the
1
st
page.
• Insufficient Printer Page Memory in the Panasonic Device, install an
Expansion D-RAM Card, or change the resolution to 300 dpi in the
Quality
tab of the Printer Driver Properties dialog box.
Printing is exceedingly slow.
• Select the Spool settings "
Start printing after first page is spooled
"
from the
Details
tab of the Printer Driver Properties dialog box.
• Select 300 dpi resolution.
• Select an outline font instead of a bit map font.
Summary of Contents for Panafax UF-8100
