Panasonic Panafax UF-580, Service Manual

Page: 25 / 114

25
555 RCV ECM D Transmitted PIN after receiving
EOR. Line is faulty and Operator Call
requested by RX side.
570 RCV B Password or machine code did not
match during remote diagnostic
communication.
571 XMT B Remote unit did not have the
remote diagnostic function.
580 XMT B Sub-address transmission to a unit
that has their DIS bit 49 (NSF bit
155) OFF. Sub-address transmission to a unit that
has no Sub-address function.
581 XMT B Sub-address Password
transmission to a unit that has their
DIS bit 50 (NSF bit 156) OFF. Sub-address transmission to a unit that
has no Sub-address function.
601 XMT ADF Door was opened during ADF
transmission.
623 XMT A No original was in the ADF. (Built-
in dialer engaged) Operator removed the original from the
ADF after dialing was completed.
Original was not set properly in the ADF.
630 XMT or RCV
(Polling)
B Redial count over. No dial tone detected. Sensor dial tone
is not detected. (destination dependent)
Busy tone is detected. (destination
dependent) T1 timer (35±5 sec.)
elapsed without a signal from the
receiver.
631 XMT A "STOP" button was pressed during
Auto Dialing.
634 XMT B Redial count over with no response
or busy tone was not detected.
Note:
U.S.A. and Canadian models
will redial only once if a busy
tone is not detected.
Telephone line cable is disconnected.
Wrong number is dialed.
SC or MJR PCB is abnormal.
638 XMT Power turned off with applicable
data in memory or during
communication. Power switched off. Power failure
occurred.
800 Relay
Comm.
The machine was requested to
relay a document but has no Relay
Hub capability.
815 Mailbox is full.
816 Conf. Polled "The received Polling Password
did not match. The machine does
not have Confidential Comm.
capability."
825 Conf. RCV
Conf. Polled
Parameter settings of the initial
sending station are not properly
set.
870 MEM XMT
Multi-Copy Memory overflow occurred while
storing documents into memory.
880 - - File Access Error.
884 - - File Access Error.
Fax Information Codes
Code Mode Phase Description of Problem Cause