Panasonic Panafax UF-580, Service Manual

Page: 21 / 114

21
3 Troubleshooting
3.1. Information Codes Table (For Facsimile)
Fax Information Codes
Code Mode Phase Description of Problem Cause
001 RCV
COPY
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor.
(1st Cassette) Recording paper jam.
Timing Sensor abnormal.
002 RCV
COPY
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor.
(2nd Cassette) Recording paper jam.
Timing Sensor abnormal.
007 RCV
COPY
C, D 1.Leading edge of the recording
paper fails to reach the Paper
Exit Sensor.
2.Recording paper has not
completely passed the Paper
Exit Sensor.
Recording paper jam.
Paper Exit Sensor abnormal.
010 RCV
COPY
B, C No recording paper. No recording paper or paper is not set
properly.
No Paper Sensor is defective.
011 STANDBY B, C Paper Cassette is not installed
properly.
012 RCV C, D The length of the received
document is over 2 meter (78.7in).
021 STANDBY
RCV
COPY
B, C, D Thermistor is abnormal.
Fuser Control is abnormal.
Fan is abnormal.
Defective SC PCB.
Defective Fuser Unit, Power Supply
Unit.
Defective Fan.
030 XMT B Read Point Sensor does not go
ON within 10 seconds after the
document starts feeding. Document is not set properly.
Defective Read Point Sensor.
031 XMT
COPY
C Transmitting document was longer
than 2 meter (or 78.7 in). The document may jam.
Defective Read Point Sensor.
041 STANDBY
RCV
COPY
B, C, D Out of toner. No toner.
Defective Toner Sensor.
043 STANDBY
RCV
COPY
B, C, D Low toner. Toner is getting low.
Defective Toner Sensor.
045 STANDBY - No Toner Cartridge. Toner cartridge has not been installed.
Defective Toner Sensor
(Cartridge Sensor).
051 RCV
COPY
- Printer Motor abnormal. Connector not properly connected.
Defective Printer Motor.
Defective SC PCB.
054 STANDBY
RCV
COPY
- HSYNC abnormal.
Motor abnormal. Defective Laser Unit.
060 - A Printer Cover is open. Cover is not firmly closed.
Connectors are not firmly connected.