Panasonic Panafax UF-580, Service Manual

Page: 30 / 114

30
030 CED & 300 bps 1 = 75 ms
2 = 1 sec Selects the pause interval between the CED and the
300 bps signal.
(Used when Echo Suppression is disabled.)
031 RTC = EOLx12 1 = Off (EOLx6)
2 = On (EOLx12) Selects the RTC signal, EOLx6 or EOLx12.
032 V34 TX START 2400-33600bps Selects the transmission modem start speed for V.34
communication, 33600-2400 bps.
033 V34 RX START 2400-33600bps Selects the receiving modem start speed for V.34
communication, 33600-2400 bps.
034 V34 TX Symbol
Rate
2400-3429sr Selects the transmission symbol rate for V.34, 3429/
3200/3000/2800/2400 sr.
Press “V” or “/\ “ to select the symbol rate.
035 V34 RX Symbol
Rate
2400-3429sr Selects receiving symbol rate for V.34, 3429/3429/
3200/3000/2800/2400 sr.
Press “V” or “/\ “ to select the symbol rate.
036 Not Used
037 PROTOCOL
DISPLAY
1 = Off (not displayed)
2 = On (displayed) Selects whether to display the modem speed during
communication.
Press “V” or “/\ “ to display.
038 Not Used
039 FLASH TIME
5 = 50 ms
~
100 = 1000 ms Selects the pause interval before activating the Flash
key.
040 E/F TIME
(Except for USA
and Canada)
5 = 50 ms
~
100 = 1000 ms Selects the pause interval before activating the Flash
key.
041 PAUSE TIME 1 = 1 sec.
~
10 = 10 sec. Selects the pause interval from 1 sec. ~ 10 sec. for
dialing through a switchboard or for international
calls.
042 Not Used
043 REDIAL
INTERVAL
0 = no waiting
~
15 = 15 minutes Selects the redial interval from 0 to 15 minutes in 1
minute steps.
044 REDIAL COUNT 0 = no redial
~
15 = 15 times
Selects the redial count from 0 to 15 times in 1 step
intervals.
Note:
In order to comply with the requirements TBR21 in
the EC destinations, do not select 15 times.
045 RING DETECT
COUNT
1 = 1 ring
~
9 = 9 rings Selects the ring detection count from 1 to 9 rings in 1
ring step intervals.
046 ON-HOOK TIME 0 = 0 sec.
~
90 = 90 sec.
Selects the on-hook time between sequential
communication calls in 1 second step intervals.
047 RESPONSE
WAIT
1 = 1 sec.
~
90 = 90 sec. Selects the waiting interval for the response after
completing the dialing.
048
049 Not Used
Function Parameter Table
No. Parameter Selections Function