Panasonic NV-HS1000, Service Manual, Page: 13 / 138

Service mode Note for checking
Number Service Data Numbers
f:::·
Disregard service data
displayed until mechanism
::::i
operation is completed.
Then the display should
indicate "00".
···••i
Display only when the
operating button is pressed.
Left digit only, disregard Right
digit display.
Right digit only, disregard left
·:::::
digit display.
Right digit only, disregard left
digit display.
Left digit only, disregard Right
t:::i
digit display.
•
Service Data
Numbers
i ;
......
r .. ·s
:
....
:
r .. ·s
......
r--·i
r•u;
......
. .
......
I I
:
....
:
f"""j
. .
L.J
.....
.....
:::j
. .
......
f:::
=
··--: ....
:
: :
.....
:
:
....
: :
. .
......
::::!
...... i::::i
..
......
.. . .
: .... : = .... :
• •
Indication
No light detected at either sensor
Tape Begining.
Light to Supply Photo Sensor is blocked.
Tape End.
Light to Take-up Photo Sensor is blocked .
Light detected at both sensors.
EJECT
Cassette-down
REV, REV SLOW
Loading/Unloading
PLAY/REC, STILUPAUSE, CUE, FWD SLOW, STOP3 •
1
STOP
02
FF/REW
Intermediate position
Any display other than '.'00" indicates a fault in the mode
switch circuit or system.
Refer to Fig. 06
i ;
......
: :
.
�L.....!.,
Left Oigilal Right Digital
:
: :
: ■
-n: :
��
Loll Digital Right Digital
;-
... ;
l!!!!!!I\..........J
Left
Right
Digital Digilal
r--·;
��
Left
A,ihl
Digital Digital
8, 9, u, A, -, n, L, and no display indicate that the Capstan
motor "PLAY" command received by IC6001.
1, 2, 3, 4, 5, 6, 7, indicate that the Capstan motor "CUE, FF,
Forward Slow" commands received by IC6001.
8, 9, u, A, -, n, L, and no display indicate that the Capstan
motor Reverse, Rew, Reverse Slow commands received by
IC6001.
1, 3, 5, 7, 9, A, n and no display indicate that the cylinder
motor "ON" command received by IC6001.
Fig. 05 Service Data Display and Indication
•
Remarks
Tape not required
Tape Reuired
* 1: STOP3;
The Pinch Roller is on the capstan
motor shaft.
*2: STOP;
The Pinch Roller is off the capstan
motor shaft .
Refer to Fig. 07 to Check mechanism
Position and timing.
Note: Supply and Take-up Photo
Sensor is inhibited .
Tape Required.
Tape not required.
Tape required.
If a symbol other than those listed is
displayed, a malfunction in that circuit is
indicated.
Tape required.
If a symbol other than those listed is
displayed, a malfunction in that circuit is
indicated.