Panasonic MC-V5491, Operating Instructions Manual

Page: 11 / 28

- 46 - - 11 -
Power Dirt Sensor Headlight Cord Length Bare Floor
120V AC (60 Hz)
Yes Yes 30 Ft Yes
FEATURE CHART
Diagrama de características
Tableau des caractéristiques
Voltaje Sensor Luz Medida Uso sin
de polvo del cordón alfombra
12.0 A/12,0 A
Si Si 9,1 m (30 pi) Si
Alimentation Détecteur
Dispositif Longueur du Position
de poussière d’éclairage cordon plancher
120 V c.a. (60 Hz)
Oui Oui 9,1 m (30 pi) Oui
BEFORE REQUESTING SERVICE
WARNING
Electric Shock or Personal Injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do
so could result in electric shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Cleaner will 1. Unplugged at wall outlet. 1. Plug in firmly. Push ON-OFF
not run. switch to ON.
2. ON-OFF switch not turned on. 2. Push ON-OFF switch to ON.
3. Tripped circuit breaker/blown 3. Reset circuit breaker or replace
fuse at household service panel. fuse.
Poor job of dirt 1. Full or clogged dust bin. 1. Empty dust bin.
pickup.
2. Broken belt. 2. Replace belt.
3. Carpet-bare floor setting incorrect. 3. Set in the correct position.
4. Clogged hose or nozzle. 4. Clean hose or nozzle area.
5. Hose not inserted fully. 5. Insert hose.
6. Worn agitator. 6. Replace agitator.
7. Hole in hose. 7. Replace hose.
8. Dust bin assembly 8. Properly install dust bin assembly.
improperly installed.
9. Belt not installed on motor shaft. 9. Install belt on motor shaft.
Bare floor option 1. Belt improperly installed with bare 1. Properly install belt.
will not work. floor selector in wrong position.
Dust escapes 1. Dust bin assembly 1. Properly install dust bin.
the dust bin. improperly installed.
Light will 1. Burned out light bulb. 1. Replace light bulb.
not work.
Dirt sensor 1. Dirty optic cells. 1. Clean optic cells.
will not work