Panasonic LUMIXDMC-FX100, Operating Instructions Manual

Page: 114 / 136

- 114 -
Connecting to other equipment
• [PAGE LAYOUT]
(Layouts for printing that can be set with this
unit)
• An item cannot be selected if the printer
does not support the page layout.
∫
Setting the date printing with the DPOF
print in advance
We recommend setting DPOF date printing
with [DPOF PRINT]
(P100) in advance when
the printer supports it. If you select
[DPOF PICTURE], printing starts and the
recording date is printed.
∫
Layout printing
• When printing a picture several times on
1 sheet of paper
For example, if you want to print the same
picture 4 times on 1 sheet of paper, set
[PAGE LAYOUT] to [
] and then set
[NUM. OF PRINTS] to 4 for the picture that
you want to print.
• When printing different pictures on
1 sheet of paper
For example, if you want to print 4 different
pictures on 1 sheet of paper, set
[PAGE LAYOUT] to [
] and then set
[COUNT] in [DPOF PRINT] (P99) to 1 for
each of the 4 pictures.
• Do not disconnect the USB connection cable
when the cable disconnection warning icon
[
] is displayed. (Depending on the printer,
the icon may not be displayed.)
• If the remaining battery power becomes low
while the camera and the printer are
connected, the status indicator blinks and
the alarm beeps. If this happens during
printing, press [MENU/SET] and stop
printing at once. If not printing, disconnect
the USB connection cable.
• The camera is receiving an error message
from the printer when the [
¥
] indication
lights orange during printing. After finishing
printing, make sure there are no problems
with the printer.
• If the total number of DPOF prints or the
number of DPOF pictures printed is high,
pictures may be printed several times. The
remaining number of prints indicated may
differ from the number set. This is not a
malfunction.
• With date printing, the setting on the printer
may take priority over the setting on the
camera. Check the date print setting on the
printer also.
• The message [USB MODE CHANGED.
PLEASE REMOVE THE USB CABLE.]
appears if you change the mode dial to a
mode other than [
] while the camera and
the printer are connected. Set the mode dial
to [
] again and then disconnect the USB
connection cable. If this happens during
printing, stop printing and then disconnect
the USB connection cable.
Settings on the printer are
prioritised.
1 picture with no frame on 1 page
1 picture with a frame on 1 page
2 pictures on 1 page
4 pictures on 1 page