Panasonic LB-DH7 Series, Operator'S Manual

Page: 81 / 92

81
Others Errors and warnings
Code
Email
notification
SNMP trap
notification
Action to be taken
W1112
s s
The command for a software update was set while software was being updated.
W1120
s s
Self-diagnostics is re-specified during self-diagnostics.
) Wait for the self-diagnostics to complete.
W2000
± ±
Performance of the changer mechanism operation in the changer
unit has deteriorated.
) The maintenance of the changer mechanism or peripheral circuit
is recommended.
W2001
W2003
± ±
Performance of the changer unit’s circuit board has deteriorated.
) The maintenance of the circuit board or peripheral circuit is
recommended.
W2010
± ±
The detected number of times of magazine loading is nearly equal
to the prescribed value.
) Check the number of times of magazine loading by Web
interface. We recommend copying the contents of the magazine
to another magazine. (
> 33) It is also possible to move the discs
to a spare magazine case by performing “Replace Magazine”.
(
> 52)
W2011
± ±
The verify function has detected that the writing quality is not
suitable for storage.
) Check the status of the magazine through the Web interface or
the S.M.A.R.T. information in the log. We recommend copying the
contents of the magazine to another magazine. (
> 38, 62)
W2020
± ±
In spite of a failure, the magazine move operation continued
normally after a retry.
) If a warning message is displayed again, draw the magazine
drawer including the magazine in question to check if all
magazines have been set correctly.
W2030
s s
An incompatible magazine has been set.
) Take out the magazine.
W2040
s s
The specified processing cannot be performed because the
magazine drawer is open.
) Close the magazine drawer and retry the processing.
W2050
s s
Failed to communicate with the drive system.
) Replacing the drive system is recommended.
W2051
W2120
s s
The specified processing cannot be performed because an
application inhibits the disc from being taken out of the drive system.
) Retry the processing after the application allows the disc to be
taken out of the drive system.
W2130
s s
The specified processing cannot be performed because an
application inhibits the magazine drawer from being unlocked.
) Retry the processing after the application allows the magazine
drawer to be unlocked.
W2140
s s
The changer unit is operating.
) Check the changer status by Web interface and retry processing
after the status changes to “Ready”.