Panasonic KX-TDA50G, Feature Manual

Page: 35 / 378

[Programming Example: System Speed Dialing Table]
Location
(System Speed
Dialing No.)
000
001
System Speed
Dialing Name
*1
ABC Company
XYZ Company
Telephone No.
*2
912125551234
913135551234
CLI Destination
*3
200
300
*1
®
8.1 [6-1] System Speed Dial— CO Line Access Telephone Number
®
[001] System Speed Dialing Number
*2
®
8.1 [6-1] System Speed Dial— Name
®
[002] System Speed Dialing Name
*3
®
8.1 [6-1] System Speed Dial— CLI Destination
5.
Displaying the Caller’s Name
In addition to the System Speed Dialing Table, each extension can store names and numbers in Personal
Speed Dialing. Therefore, it is entirely possible for the same telephone number to be stored under a
different name in different locations within the PBX.
When a call containing Caller ID information is received, the PBX will search for the caller’s name in the
following order, then show that name on the display and log it via SMDR.
1.
Personal Speed Dialing data of the extension which received the call
2.
System Speed Dialing Table
3.
The Caller ID information received from the telephone company
If a caller’s name is not stored in the PBX or sent from the telephone company, it will not be displayed or
logged.
Conditions
[General]
•
Caller ID signaling type can be selected through system programming.
[Caller ID to SLT Port]
•
Hardware Requirement:
KX-TDA50: The EXT-CID card
KX-TDA100/KX-TDA200: An SLC8 card with an EXT-CID card installed, or a CSLC16 card
KX-TDA600: An SLC8 card with an EXT-CID card installed, a CSLC16 card, or an ECSLC24 card
•
When the caller’s number is sent to an SLT, a CO Line Access number can be automatically added to the
telephone number through system programming for calling back.
•
KX-TDA50 only
Through system programming, a group of 4 SLT or Super Hybrid ports can be assigned to receive Caller
ID information. Up to 2 groups can be programmed. Therefore, a maximum of 8 SLTs can receive Caller
ID information.
Note that SLTs connected in parallel to DPTs attached to Super Hybrid ports can only receive Caller ID
information when set to "ring" mode.
•
When the caller’s number exceeds 16 digits, the SLT receives only the first 16 digits, not counting the
preceding CO Line Access number (if it is programmed to be added).
•
If a call is transferred to an SLT, the transferring extension’s information will be shown on the SLT. If the
transferring extension goes on-hook before the call is answered, the original caller’s information will be
shown.
•
When Caller ID information such as "Private", "Out of Area", or "Long Distance" is received, this information
will be shown instead of the caller’s number and name.
Document Version 2008-11 Feature Manual 35
3.1.1 Caller ID