Panasonic KX-TDA50G, Feature Manual

Page: 24 / 378

Destination Availability
DISA
Analog/ISDN Remote Maintenance
Idle Line Access no. + Phone no.
Trunk Group Access no. + Trunk Group no. + Phone no.
Extension of Another PBX (via TIE Line, Access with PBX Code)
Extension of Another PBX (via TIE Line, Access without PBX Code)
*1 A PS destination can be used to forward fax calls to a fax machine at another PBX connected by TIE line. A virtual PS can be specified
as the destination of fax calls. Then, the extension number of the fax machine at the other PBX can be specified as the FWD—ALL
Calls destination for calls to that virtual PS. (
®
19.1.2 Virtual PS)
Conditions
•
Hardware Requirement: An MSG2 card or ESVM2 card
•
This feature is only effective for calls arriving on DISA lines.
•
If a fax signal is not detected before the DISA Intercept Routing—No Dial timer expires, the call is redirected
to the operator extension, and fax detection ends.
Installation Manual References
2.5.3 MSG2 Card (KX-TDA5191)
2.5.5 ESVM2 Card (KX-TDA5194)
PC Programming Manual References
7.4 [5-3-2] Voice Message—DISA Message— Fax Extension (KX-TDA50 only)
Feature Manual References
4.1.7 DISA (Direct Inward System Access)
21.2 Exclusive Features Table
1.1.7 Automatic Time Adjustment
Description
The PBX clock can be adjusted automatically in the following two ways:
1.
Daylight Saving Time Setting
The start and end dates of Daylight Saving Time can be programmed. The PBX clock will automatically
adjust itself one hour forward or backward at 2:00 A.M. on the programmed date, if enabled through system
programming. At 2:00 A.M. on the start date, the clock will change to 3:00 A.M., and at 2:00 A.M. on the
end date, the clock will change to 1:00 A.M.
Note
If a Timed Reminder (Remote Wake-up call) is set:
–
On the Daylight Saving Time start date, a reminder set for between 2:00 A.M. and 3:00 A.M. will
not ring.
24 Feature Manual Document Version 2008-11
1.1.7 Automatic Time Adjustment