45
Setup
Make sure the SCSI ID No. of the scanner is 2 and that of the
printer is 1. (They are the default settings.)
B
If you have other devices connected to the computer, make sure that each
SCSI device has a different ID No.
B
To change an ID No., use ID No. switches (#1, #2, #3) located on the back
of the units. Also refer to Table 1 on
page 52
.
Make sure the terminator switch (#4) of the scanner is set to OFF
and that of the printer is set to ON. (They are the default settings.)
B
If you have other devices connected to the computer, make sure the
terminator switches of all those devices are set to OFF.
B
To change the terminator setting, use the terminator switch (#4) located on
the back of the units.
Connect the power cords to the scanner’s AC inlet, to the
printer’s AC inlet and to AC outlets.
4
5
6
1
2
3
4
ON
12
3
4
ON
Scanner
Printer
