Panasonic KX-NS700, Installation Manual

Page: 239 / 308

8.
Move the mouse pointer over System Property .
A menu will be shown under the mouse pointer.
9.
Click Site .
10.
Click the Port Number tab.
11.
Program the following items according to the protocol used by KX-UT series SIP phones in the remote site.
a.
When the KX-UT series SIP phones are using HTTPS:
•
CWMP (HTTPS) Port No. for SIP-MLT
•
Data Transmission Protocol (HTTPS) Port No. for SIP-MLT
b.
When the KX-UT series SIP phones are using HTTP:
•
CWMP (HTTP) Port No. for SIP-MLT
•
Data Transmission Protocol (HTTP) Port No. for SIP-MLT
Note
For the default port numbers of the PBX, refer to "8.6 Port Security".
12.
Click OK .
Using the PBX as an NTP server
When the PBX will be used as an NTP server, follow the procedures below.
1.
Click Setup
®
Network Service
®
Server Feature
®
NTP .
2.
Select Enable .
3.
Click OK .
Programming the router at the main site with Built-in Media Relay Gateway
Port forwarding settings (Router – PBX)
Configure the following items for port forwarding between the Media Relay Gateway and the router.
For the KX-NT500 series:
Application LAN Side Port Number WAN Side Port Number
PTAP Signaling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.15 PBX Configuration—[1-1]
Configuration—Slot—Card
Property—V-SIPEXT")
Signaling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.15 PBX Configuration—[1-1]
Configuration—Slot—Card
Property—V-SIPEXT")
MGCP Signaling (MGCP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.15 PBX Configuration—[1-1]
Configuration—Slot—Card
Property—V-SIPEXT")
NAT - MGCP Server Port No.
(Use the same value as in step 5 of
"Programming the PBX with Built-in
Media Relay Gateway".)
RTP (UDP) Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the PBX
uses.)
*1
Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the PBX
uses.)
*1
Make sure the RTP Start Port (UDP) and the RTP End Port (UDP) specified
for the router are in the range of the RTP ports that the PBX uses. For the
range of RTP port numbers that the PBX uses, refer to "Port Numbers for
Optional DSP Card" in "8.6 Port Security".
*1
Document Version 2016-03 Installation Manual 239
5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway