Panasonic KX-NS700, Installation Manual

Page: 171 / 308

e.
Select Use the following DSP IP address .
f.
Enter up to 2 IP addresses
*1
for each installed DSP card.
g.
Click Next .
*1 Valid IP address range: "1.0.0.1" to "223.255.255.254"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except "0.0.0.0" and "255.255.255.255")
7.
In the VoIP (Ext) settings:
In Number of IP Extensions :
a.
In IP-PT(NT) , specify the number of IP-PT extensions.
b.
In UT/UDT , specify the number of UT extensions.
c.
In SIP-Phone , specify the number of SIP extensions.
Note
You can confirm the required number of virtual IP extension cards, total IP extensions and total
virtual IP extension cards.
d.
In IP Terminal Registration Mode , select one of the following options:
•
Manual : Manually register IP terminal information.
•
Full Automatic : Automatically register IP terminal information.
•
Extension Number Input : Automatically register IP terminal information except the extension
number. The extension number can then be registered from the IP telephone manually.
Note
•
The Full Automatic and Extension Number Input registration modes may not be available for
certain types of IP terminals. In such cases, select Manual as the registration mode.
•
For more information about the IP terminal registration modes, refer to "5.8.1 Registering IP
Telephones".
e.
In DHCP Server , select either Disable or Enable .
f.
If you select Enable in DHCP Server , enter valid settings for the automatic assignment of IP addresses.
g.
Click Finish .
8.
Follow the prompts of the Easy Setup Wizard. If LAN settings were changed from their default values in
step
6 , you will be prompted to restart the PBX after the Easy Setup Wizard is complete. Click OK to restart
the PBX. The login screen will be displayed. Click Skip to finish the Easy Setup Wizard and continue the
configuration from the home screen without restarting the PBX.
Notice
If you select Skip , restart the PBX after completing the settings.
9.
Log in with the Installer level account using the password entered during Easy Setup Wizard. The Home
Screen is displayed. You may now begin programming the PBX.
Notice
If an external DHCP server is in use, it must be able to use the "client identifier" option specified by
RFC 213.
Changing IP Address Settings
IP addressing information for the PBX can also be changed from Web Maintenance Console after the Easy
Setup Wizard has been completed.
1.
Click Setup
®
Network Service
®
IP Address/Ports .
2.
Click the Basic Settings tab.
3. When using a DHCP server:
a.
Select Obtain an IP address automatically .
b.
Select Obtain DNS server address automatically .
Document Version 2016-03 Installation Manual 171
5.4.1 Easy Setup Wizard