Panasonic KX-NS1000, Pc Programming Manual

Page: 391 / 1294

Voice (RTP) UDP Port No. (IP-CS)
Specifies the UDP port used to transmit and receive RTP (Real-time Transfer Protocol) data on the IP-CS side.
This must be changed if another network application is using the same port.
For voice communications, an IP-CS uses 128 contiguous UDP ports, starting from the port number specified
here.
To change the value displayed here, click
Common Settings and set the desired value.
Default
8000
Value Range
1024–65024
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
Keep Alive Time-Out
Specifies the length of time that the PBX will continue to consider an IP-CS to be active even if it receives no
transmissions from that IP-CS. The PBX constantly confirms the status of IP-CSs. If no communications are
received from an IP-CS for the duration specified here, the PBX considers the IP-CS to be unreachable, and
sets the port status to
Fault .
During operation, set between 10 s and 60 s. Settings over 60 s, and Disable , are used for debugging purposes,
and IP-CSs cannot be guaranteed to function normally in these circumstances. Do not use debugging settings
unless instructed to do so.
To change the value displayed here, click
Common Settings and set the desired value.
Default
20 s
Value Range
Disable, 10–120 s
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
First Resending Time (PTAP)
Specifies the length of time that the PBX waits before starting to resend PTAP (Panasonic Telephony
Administration Protocol) data.
To change the value displayed here, click
Common Settings and set the desired value.
Default
500 ms
Value Range
500
´
n (n=1–16) ms
Document Version 2016-03 PC Programming Manual 391
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property