4.
Not using a DHCP server when the IP-PT is on the remote office LAN
All the IP addressing information must be assigned manually.
Follow the procedure below to assign the IP addressing information.
If you need to set VLAN parameters, follow the procedure described in "4.4.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
KX-NT300 series (except KX-NT321)
Select "Network".
ENTER
Select "Disable"
for DHCP setting.
ENTER
IP Address*
1
ENTER
To set the IP address of the IP-PT
To set the subnet mask address
To set the default gateway address
Select "Default Gateway".
ENTER
Default Gateway Address*
3
ENTER
ENTER
Subnet Mask Address*
2
ENTER
Select "Subnet Mask".
Select "IP Address".
To start programming
Press "SETUP" when it is displayed.
SETUP
Supply power to the IP-PT.
Select "PBX".
Return to the
Menu screen.
PBX IP Address
ENTER
ENTER
To enter the IP address of the IPCMPR card (PBX IP Address)
Select "PBX IP
Address".
Select "Primary
PBX".
ENTER
ENTER
Software version 2.00 or later only
Continued on next page
56
IP Networking Guide
Document Version 2009-12
4.4.1 Assigning the IP Addressing Information
Summary of Contents for KX-NCP500
