Panasonic KX-NCP500, Manual

Page: 39 / 96

4.2.3 Programming the Network Settings
For successful operation of a VoIP network using the V-IPGW16 card, network settings for the PBX at each
location must be programmed appropriately. For a detailed discussion of related features, refer to the Feature
Manual.
This section details the procedure to program the network settings for the local PBX. After the programming
for the local PBX has been done, repeat the procedure for the remote PBX with the appropriate setting values.
The following procedures describe the process of programming the network settings for each numbering
method.
Programming for the PBX Code Method
1. a.
Under Configuration , click Slot .
b.
Move the mouse pointer over the PBX image of
IPCMPR Virtual Slot at the top of the screen.
c.
Click Select Shelf .
d.
Move the mouse pointer over the installed
V-IPGW16 card to display the menu of options.
e.
Click Port Property .
Confirm that all ports are in service ( INS ).
Note
When a V-IPGW16 card is installed, 8 ports (1–8)
are available. When two V-IPGW16 cards are
installed, 16 ports (1–16) are available.
2.
a.
From the system menu, click CO & Incoming Call .
b.
Click CO Line Settings .
c.
Type the CO Name and assign an unused Trunk
Group Number to be used for all IP CO lines.
d.
Click OK .
3. a.
From the system menu, click System .
b.
Click Numbering Plan .
c.
Click Main .
d.
Click the Features tab.
e.
In the TIE Line Access box, type the dialing number.
f.
Click OK .
Document Version 2009-12 IP Networking Guide 39
4.2.3 Programming the Network Settings