Panasonic HYBRID IP-PBX KX-TDA200, Features Manual

Page: 405 / 464

2.3 System Data Control
2.3.1 PC Programming
Description
This PBX can be programmed and administered using a PC. There are two programming methods:
1.
On-site Programming: System programming/diagnosis can be performed locally by connecting a PC to
the PBX directly.
2.
Remote Programming: System programming/diagnosis and data upload can be performed from a remote
location.
1.
On-site Programming:
Method Description
Using the Serial Interface
(RS-232C) port The PBX has a Serial Interface (RS-232C) port which can be used for
either system administration or SMDR (
®
1.26.1 Station Message
Detail Recording (SMDR)).
Using the USB port The PC is connected to the USB port of the PBX, or a USB port (USB
Module) attached to a DPT.
Using the LAN interface A CTI-LINK card (KX-TDA100/KX-TDA200/KX-TDA600 only) or an
IP-GW4 card (KX-TDA30 only) must be installed.
Using a modem through an
SLT port
*1
An RMT card must be installed. Assign the floating extension number
of the analogue remote maintenance (default: 599), and dial this num-
ber from the PC to connect to the PBX.
Using an ISDN TA interface
(64 kbps) through an ISDN
Extension Line
*1
Assign the floating extension number of the ISDN remote maintenance
(default: 699), and dial this number from the PC to connect to the PBX.
The RMT card is not required for this method.
This method is available only when a user-supplied ISDN TA that sup-
ports CAPI is used.
*1 If remote access is disabled through system programming, then this on site programming cannot be done.
2.
Remote Programming:
Feature Guide 405
2.3.1 PC Programming