Panasonic FPSIGMA, Technical Manual

Page: 44 / 94

Wiring of the FP-FNS Blocks
43

After wiring, make sure stress is not applied to the wire.

In the terminal block socket, make sure to clamp the wire in place by turning
the tightening screw clockwise.
4.6.3 FP-FNS Block CANopen Wiring
Use a standard CANopen cable and standard 9-pin Sub-D female CANopen connectors.
We recommend using a straight (0°) bus interface connector. When a horizontal (90°) bus
interface connector is used, the cables will be directed toward the top of the unit, which may
cause difficulties when installing other devices in a control cabinet.
4.6.4 FP-FNS Block PROFINET IO Wiring
PROFINET uses a transmission rate of 100Mbit/s in full-duplex mode for data communication.
Therefore, the cables used must fulfill these requirements. Use a standard, shielded,
twisted-pair Ethernet cable (100 BASE TX) with a minimum category 5 rating and at least four
wires. For example, STP5 is a shielded, twisted pair cable of category 5.
Please use standard RJ45 connectors. RJ45 connectors are available with different IP degrees
of protection.
The maximum distance between two devices should not exceed 100m.
4.6.5 FP-FNS Block BACnetIP Wiring
BACnetIP uses a transmission rate of 10/100Mbit/s in full or duplex mode for data
communication. Therefore, the cables used must fulfill these requirements. Use a standard,
shielded, twisted-pair Ethernet cable (100 BASE TX) with a minimum category 5 rating and at
least four wires. For example, STP5 is a shielded, twisted pair cable of category 5.
Please use standard RJ45 connectors. RJ45 connectors are available with different IP degrees
of protection.
The maximum distance between two devices should not exceed 100m.