Panasonic FPSIGMA, Technical Manual

Page: 43 / 94

Installation and Wiring
42
2. Wrap the end of the cable with 38mm (1.5in.) of shrink wrap, covering part of the
exposed conductors and part of the trunk line insulation.
3. Strip 8.1mm (0.32in.) of the insulation from the end of each of the insulated
conductors.
4. Insert each conductor into the appropriate clamping cavity of the open style
connector or the screw terminal on the device, according to the color of the cable
insulation:
Wire color Wire identity Usage
White CAN_H Signal
Blue CAN_L Signal
Bare Drain Shield
Black V- Power
Red V+ Power
5. Tighten the clamping screws to secure each conductor. The male contacts of the
device connector must match the female contacts of the connector.

When removing the wire's insulation, be careful not to scratch the core wire.

Do not twist the wires to connect them.

Do not solder the wires to connect them. The solder may break due to
vibration.