Panasonic FP-M Hardware, Manual

Page: 252 / 268

244
8-14. Product Types
■
Structure of board type
3. Programming Tools
■
FP Programmer II
■
NPST-GR Software
Note:
• The specifications for each cable used for communications are shown on page 246 to 248.
Type
NPST-GR Software Ver.3
FP-M Personal Computer
Cable (for NPST-GR)
(See note.)
RS232C Interface
Adapter
RS232C Cable
(See note.)
Description Part number
AFP266538
AFC8513
(3 m/9.8 ft.)
Needs to be
made to match
your computer
Needs to be
made to match
your computer
Program editing software used
System required: IBM PC-AT or 100 % compatible with 2 MB or
more hard disk drive, MS-DOS Ver. 3.30 or
higher, and EGA or VGA display mode
Cable needed for connection between the programming tool
port of FP-M control board and D-SUB 25 connector of
RS232C interface adapter.
Adapter needed for connection between the programming tool
port of FP-M personal computer cable (for NPST-GR) and
RS232C interface (9 or 25 pins) of personal computer.
Refer to example of adapter specifications on page 245.
Cable needed for connections between the RS232C port of C
type control boards (C20RC/C20TC/C32TC) and RS232C
interface (9 or 25 pins) of your personal computer.
Type
FP Programmer
II
FP-M Peripheral Cable
(for FP Programmer
II
)
(See note.)
Description Part number
AFP1114
AFC8521
(1 m/3.3 ft.)
AFC8523
(3 m/9.8 ft.)
Hand held programming tool for FP programmable controller.
Cable needed for connection,
- between the programming tool port of FP-M control board and
FP Programmer II communication port (RS232C interface).
- between the FP-M control board and FP data access unit.
1
Screws (8 mm)
2
Screws (20 mm)
3
Connector P.C.B.
4
Control board
5 Spacers (20 mm, AFB88021)
6 Expansion board
7 Spacers (20 mm, AFB8802)
1
5
4
7
6
7
6
7
6
7
6
2
3
5
7
7
7
7