Panasonic FP-M Hardware, Manual

Page: 198 / 268

190
8-5. System Registers
Address
7
8
14
20
26
31
Name of system register
Hold area starting
address settings for
internal relays
Hold area starting
address settings for
data registers
Hold/non-hold settings for
step ladder
Operation settings for
duplicated use of output
Operation settings when
an operation error occurs
Waiting time settings for
multi-frame communication
Default
value
K10
K0
K1
K0
K0
K2600
(6500 ms)
Description
Hold area starting address for internal relays is specified in
word-units.
• Setting range
K0 to K63
• If the maximum value of the setting range is input, all of
the areas are used as non-hold areas.
EXAMPLE:
If system register 7 is set to K30:
- Non-hold area:
- Hold area:
Hold area starting address for data registers is specified.
• Setting range
FP-M 2.7 k type: K0 to K1660
FP-M 5 k type: K0 to K6144
• If the maximum value of the setting range is input, all of
the areas are used as non-hold areas.
EXAMPLE:
If system register 8 of FP-M 2.7 k type is set to K10:
- Non-hold area:
- Hold area:
Hold/non-hold settings for step ladder operation are specified.
K0: Hold
K1: Non-hold
This register specifies the operation of the FP-M when a
duplicated use of output is programmed.
K0: a duplicated use of output is regarded as a
total-check error.
K1: a duplicated use of output is not regarded as an error.
This register specifies the operation of the FP-M when an
operation error is detected.
K0: FP-M stops operation if an operation error occurs.
K1: FP-M continues operation even if an operation
error occurs.
This register specifies the maximum waiting time between
delimiters when multi-frame communication is performed
with the computer link.
• Setting range
(set value: K4 to K32760) × 2.5 ms [10 ms to 81900 ms]
Note:
• When you set this register using NPST-GR Software, set
a time that can be divided by 2.5.
R0 to R29F
R300 to R63F
DT0 to DT9
DT10 to DT165