Panasonic CN-NVD905U - Strada - Navigation System, Operating Instructions Manual

Page: 22 / 118

Check mounting and wiring
GPS information
Check GPS information reception.
1
Select [GPS Info] from the
Information menu.
 The GPS Info screen is displayed.
2
Check the reception.
 Use a clearly visible point to check reception.

Check that at least three satellite numbers
are being received, and that the latitude and
longitude are displayed.
Note:
 If GPS reception is not continuous, check connections
to the GPS antenna, and its mounting position.
Installation confi rmation
Check the state of mounting and wiring.
 Refer to the Installation Instructions for details.
1 Press
.
 The Navigation menu is displayed.
2
Select [Information].
 The Information menu is displayed.
3
Select [Install. Status].
4
Check mounting.
 The items you can check are shown in the table
on the right.

The items you can check
GPS Antenna If the antenna is connected normally,
this indicates “ON”.
Lighting
Switch If the vehicle side lights are switched
on, this changes to indicate “ON”.
Reverse When the shift lever is shifted to
reverse, this changes to indicate “ON”.
Parking Brake When the parking brake is pulled, this
changes to indicate “ON”.
Speed Vehicle speed is displayed.
ACC Voltage The display should normally be
approximately 12 V. (11 to 16 V)
Speed Pulse The reading changes to “0” when
[Pulse Reset] is pressed. If the system
is functioning normally, the number
should be different after the vehicle
has moved.
Accuracy
Level The reading changes to “0” when
[Level Reset] is pressed. The number
changes after the vehicle has moved.
(Level 4 is the maximum)
Sensor Reset The reading changes to uncorrected
when [Sensor Reset] is pressed.
Note:
 In the following situations, please reset “Speed Pulse”,
“Accuracy Level” and “Sensor Reset”.

The unit has been transferred to another vehicle.

The tires have been changed.

The tires have been rotated.
 On routes that involve congestion and frequent
stop-start driving, such as in town, routes with many
left and right turns, and routes where GPS signal
reception is poor, the correction process could take a
long time and leave errors in the stored content.
 For some vehicle models, the vehicle mark may stop
moving when speed increases, but that does not
indicate a malfunction when it takes place during the
correction process.
Installation setting
Set the state of mounting and wiring.
 Refer to the Installation Instructions for details.
1
Select [Install. Setting] from the
Information menu.

The Install. Setting screen is displayed.
2
Make settings.

Speed Signal:
Set the speed signal detection level. (It should
be set to [Normal] in normal circumstances.)
Select [Low Level] if the voltage of the speed
signal is low and the signal cannot be detected.
default:
[Normal]
 Rear View Camera:
Set whether or not to switch to the
image from the rear view camera when
the shift lever is in the reverse position.
(

System Upgrade Guidebook)
[On]: Set this if a rear view camera is
connected.
[Off]: Set this if no rear view camera is
connected.
default: [Off]
Note:
 The image from the rear view camera may be
blurred in the night or a dark place.
 H/F Speaker:
Set the speakers to use for audio output of
hands-free conversation if a hands-free kit
featuring Bluetooth
®
technology (CY-BT100U,
option) is connected.
[Both]: Front Left/Right speaker
[Lch]: Front Left speaker
[Rch]: Front Right speaker
default: [Both]
English English
22 23
23 22