Panasonic CN-NVD905U - Strada - Navigation System, Operating Instructions Manual

Page: 57 / 118

Search again for the route
During route guidance, the route search can be repeated
when the current position screen is displayed. The
search conditions used for the route currently followed
can be changed for a new search.
1
Select [Route] on the current
position screen.
 The Re-route search screen is displayed.
2
Select search conditions from
[Quick1]/[Quick2]/[Short].
 Searching starts and guidance of the new route
begins.

[Quick1]: The search looks for a route with the
shortest travel time. (Recommended
route)

[Quick2]: The search looks for a route that
differs from the displayed route but
uses the same search conditions as
the current guidance route.

[Short]: The search looks for a route with the
shortest distance to the destination.
Note:

If multiple destinations have been set, the search to
the next destination is repeated.
Edit the route
(continued)
Set search conditions for each section of the route
Search conditions ([Quick1]/[Quick2]/[Short]) can be set
for each section.
1
Select [Route] on the current
position screen.
 The Re-route search screen is displayed.
2
Select [Route].
 The Change Route screen is displayed.
3
Select [Search condition].
 The Search Condition screen is displayed.
4
Select the search conditions for each
section.

Select search conditions from [Quick 1]/
[Quick 2]/[Short].

If there are transit destinations, only [Quick] and
[Short] will be displayed for sections after the
fi rst transit destination.

[Quick]: The search looks for a route with the
shortest travel time. (Recommended
route)

[Short]: The search looks for a route with the
shortest distance to the destination.
The search looks for nearby
detour routes
It can search for a route that detours around the route
ahead of the vehicle.
1
Select [Route] on the current
position screen.

The Re-route search screen is displayed.
2
Select [Detour].
 The Detour screen is displayed.
3
Select the detour distance.
 The possible detour distance varies with the
distance setting (

page 84) and the road
currently used.
 Searching starts and guidance of the new route
begins.
 To detour around entire the whole route, select
[Entire route].
Note:

This function can only be used while driving along the
route.
 In some cases the route displayed may not be a
detour.
5
Select [OK].
 The All route screen is displayed after the search
is complete.
6
Select [Start].
 Route guidance starts.
miles km
General road
1 mile
3 miles
5 miles
1 km
3 km
5 km
Highway
5 miles
15 miles
25 miles
5 km
15 km
25 km
English English
56 57
57 56