If the unit fails to operate
IMPORTANT
Push the switch only when the unit fails to operate
with any buttons. (Stored settings and adjustments
are cleared.) If the unit fails to return to normal,
contact the nearest Panasonic Servicenter and have it
repaired.
Note:
If the ID code has been already set, you will be asked
to enter the ID code right after the unit is restarted.
A noise may occur when the reset switch is pressed,
but that does not indicate a malfunction.
Error display messages
Display
Possible cause
Possible solution
No map data
A location not within the area of the recorded map is trying to be displayed.
It is not a malfunction. Use the unit within the area covered by the map.
Destination too far.
Please set a point
within 3200 miles
(5000 km*) in a
straight line.
Guidance is impossible because the destination is too far away.
Reconsider the area conditions, or set destinations to pass through, then
search again.
HDD cannot be
read due to low
temperature.
The system could not start up due to abnormal HDD temperature.
Turn off the power and wait for a while before turning the power back on.
HDD cannot be
read due to high
temperature.
Not compatible with
DTS.
Please select
alternative mode.
A dts DVD was played.
This system is not compatible with dts. If the DVD contains non-dts sound,
switch to that.
No disc
No disc is in the player.
Insert disc into the disc slot.
Incorrect region disc
An attempt was made to play a disc with a region number other than “1” or “ALL”.
Check the disc.
Sound settings
Problem
Possible cause
Possible solution
No sound from left,
right, front, or rear
speaker.
Cables are not correctly connected.
Connect the cables correctly.
Left and right sounds
are reversed.
The speaker leads are connected in reverse between right and left.
Connect the speaker wires to the correct one.
No sound from the
subwoofer
Playing back a disc having a subwoofer channel.
Troubleshooting
(continued)
Error display messages
Display
Possible cause
Possible solution
Hardware error.
Reboot or press reset
switch.
There was a malfunction in the amp.
Press the reset switch on the system.
(
follows)
Read error
Some mechanical or operation error has occurred.
If there is no response to pressing the eject button, restart the engine.
Cannot play this disc
The inserted CD/DVD cannot be read.
Refer to “Discs that can be played back”
(
page 7)
and use the right kind of
disc.
Some mechanical or operation error has occurred.
If there is no response to pressing the eject button, restart the engine.
Product servicing
If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized
Panasonic Servicenter. The product should be serviced only by a qualifi ed technician.
Replacing the Fuse
Use fuses of the same specifi ed rating (
15 A
). Using different substitutes or fuses with higher rating, or connecting
the product directly without a fuse, could cause fi re or damage to this unit.
If the replacement of the fuse fails, contact your nearest Panasonic Servicenter for service.
Reset the system
Reset switch
Insert a hard, slender stick into the hole and push the
switch.
* This is the distance when “km” is set as the distance setting (
page 84).
English
English
104
105
104
105
Summary of Contents for CN-NVD905U - Strada - Navigation System
Page 117: ...Memorandum 343 ...