System 1/2 screen
System 1/2
Frequency 59.94Hz
Format 2160/59.94p
Genlock
Horizontal Phase 0
Tracking Data Output
Serial Off
IP Off
Invert Pan/Tilt Axis Off
Return
Frequency [59.94Hz, 50Hz, 24Hz, 23.98Hz]
This item is selected to switch the frame frequency.
• For details on how to change the frequency, refer to “Changing the
frequency” (→ page 58).
Format
For [59.94Hz]
2160/59.94p, 2160/29.97p, 1080/59.94p, 1080/59.94i, 1080/29.97p,
1080/29.97PsF, 1080/23.98p(59.94i)
*
1
, 720/59.94p
For [50Hz]
2160/50p, 2160/25p, 1080/50p, 1080/50i, 1080/25p, 1080/25PsF,
720/50p
For [24Hz]
2160/24p, 1080/24p
For [23.98Hz]
2160/23.98p, 1080/23.98p, 1080/23.98PsF
*
1
It denotes “1080/23.98p over 59.94i”.
<NOTE>
• Streaming stops when changing the system format.
• For details on how to change the format, refer to “Changing the
format” (→ page 58).
Genlock
This item is selected to perform the phase adjustments.
Horizontal Phase [–206 to +49]
This is used to adjust the horizontal phase during genlock.
Tracking Data Output
Settings for the output of tracking data to be used in a virtual studio
system or elsewhere. (→ page 59)
Serial [Off, On]
Sets the function [On] or [Off] to output the tracking data, such as
Pan/Tilt/Zoom or other information from Serial Output (RS-422),
synchronized with the Genlock signal. (→ page 59)
<NOTE>
• The serial connection of the remote controller (AW-RP150 or
AW-RP60, etc.) cannot be made if [Serial] is already [On].
• In the following cases, the tracking data output may be delayed or
the value may not be updated.
- While viewing the OSD menu
- While recalling the preset value during an ongoing preset recall
- When executing AWB/ABB
- When a red or a green tally signal input has been changed
between Off and On
- When deleting a preset memory
- When an output image is flipped (turned upside down or left-right
reversed)
- After switching [Scene]
- After switching [Iris Mode]
- After switching [Super Gain]
- After switching [White Balance Mode]
- After switching [Gamma Mode]
- After switching [Matrix Type]
- After switching [Focus Mode]
- After switching [Zoom Mode]
- After switching [Max Digital Zoom]
- After switching [Digital Extender]
- After switching [Fan]
- After switching [OSD Mix]
- After switching [Tally]
- After switching [Install Position]
- After switching [Preset Speed Unit]
- When executing [Initialize] of [Maintenance]
56
Camera menu items (continued)
