Setting the remote control IDs
The wireless remote control (optional accessory) is capable of operating
up to four units.
IDs are used to set which units are selected when the CAMERA <1>,
<2>, <3> and <4> buttons on the wireless remote control have been
pressed.
• When operating a multiple number of these units using wireless
remote controls, set a different remote control ID for each control.
• When using one unit, set the remote control ID to “CAM1” unless the
setting needs to be changed.
Setting procedure
Operate the IR ID switches on the unit's rear panel, and select “CAM1”,
“CAM2”, “CAM3” or “CAM4” as the remote control ID. (→ page 18)
The IR ID switch settings “CAM1” to “CAM4” correspond to the
CAMERA <1> to <4> buttons on the wireless remote control.
(The factory setting is “CAM1”.)
RS-422
IR ID
3G SDI OUT
G/L IN
AUDIO IN
LAN
LINK
ACT
DC IN 12V
SERVICE
IR ID switches
SET
MODE ON
ー
OPT
ー
OFF
OFF
LOW
HI
AUTO
MENU
CAMERA
GAIN
1
2
3
4
1
4
7
10
11
12
8
9
5
6
2
3
PRESET MEMORY
PRESET
LIMIT
HOME
CAMERA <1> to <4> buttons
Setting the installation method (“Desktop” or
“Hanging”) from the OSD menu
Set “Desktop” or “Hanging” in [Install Position] on the [Pan/Tilt] screen
from the OSD menu of this unit.
Pan/Tilt
Install Position Desktop
P/T Speed Mode Normal(60deg/s)
P/T Acceleration Setting
Speed With Zoom Position On
Focus Adjust With PTZ. Off
Privacy Mode Off
Power On Position Standby
Preset Number 001
Return
Install Position [Desktop, Hanging]
[Desktop] or [Hanging] is selected here as the method used to install
the unit.
Desktop Stand-alone installation
Hanging Suspended installation
<NOTE>
• When [Hanging] has been selected, the top, bottom, left and right
of the images will be reversed, and up/down/left/right control for
panning and tilting will also be reversed.
26
