16
1. Functions in each area
1-9. Rear panel connections area
POWER
1
REF
SLOT2
2
SLOT
4
2
3
4
SLOT1
1
SLOT2
8
~
IN
SDI INPUTS
TALLY
6
6
INPUTS
SDI OUTPUTS
IN
OUT
3
IN
OUT
2
IN
OUT
1
IN
OUT
OUTPUTS
1
5
7
SLOT
OFF
2
SLOT1
5
SLOT
SLOT
PGM
RS-422
LAN
ON
ANALOG INPUTS
Y
Pb
Pr
Y
Pb
Pr
DVI INPUTS
ANALOG OUTPUTS
Y
Pb
Pr
Y
Pb
Pr
DVI/ANALOG OUTPUTS
Y
Pb
Pr
DVI-I
DVI-I
DVI-I
GPI
SIGNAL
GND
R
SDI signal input connectors [DIGITAL INPUTS 1 to 4]
IN: SDI signal input; OUT: active through output (use this as a monitor output application).
S
Optional input connector SLOT1 [INPUT 5, 6] (optional)
T
Optional input connector SLOT2 [INPUT 7, 8] (optional)
A board (with built-in up-converter), whether an SDI input board, analog input board or DVI input board, can be
connected to each of these slots.
For further details, refer to the operating instructions of the optional board concerned.
U
SDI signal output connectors [DIGITAL OUTPUTS PGM, OUTPUT 1, 2]
PGM:
PGM output connectors
OUTPUT 1, 2: The signals for these connectors can be assigned using a menu.
V
Optional output connector SLOT1 [OUTPUT 3, 4] (optional)
A board, whether an analog output board or DVI/analog output board (OUTPUT3: DVI, OUTPUT4: analog), can
be connected to this slot.
For further details, refer to the operating instructions of the optional board concerned.
W
Optional output connector SLOT2 [OUTPUT 5, 6] (optional)
A board, whether an analog output board or DVI/analog output board (OUTPUT5: DVI, OUTPUT6: analog), can
be connected to this slot.
For further details, refer to the operating instructions of the optional board concerned.
X
Reference input connector/BB output
connector [REF]
Loop-through output in the external sync mode.
If the loop-through output is not going to be used,
provide a 75-ohm termination.
BB signals output from both connectors in the internal
sync mode.
<In the external synchronization mode>
External synchronization signal input
Loop-through output
REF
Input the external synchronization signal to the upper of
the two connectors shown above.