ANUP5204 Aicure
Irradiation
29
and UV intensity appear in the display.
8
Press the up and down arrow buttons to change the value
(%). Press the up arrow button to increment the value.
Press the down arrow button to decrement the value.
Press and hold one of the buttons to speed the rate of
increase/decrease.
The value can be set in a range of 0.0 to 100%, in
increments of 0.5%.
9
Press the "SET" button until you hear a beep (at least 1
second).
If this is the value you wish to set, press the "SET" button
to register it.
Once a step is registered, the system moves to the next
step setting automatically. The "UV POWER" LED goes
out, and the "TIME" LED under the display begins to flash.
The step number and timer value appear in the display.
10
Repeat steps 6 through 9 for the following steps.
Register steps 0 through 9. After step 9 has been
registered, step setup ends automatically.
To end irradiation before step 9, set the timer value of the
step before the final step to "0.0". Execution ends at that
step.
When you end the step setting, the display returns to the
pattern number.
To quit from step setting midway, press the up and
down arrow buttons simultaneously, or wait for one
minute or more.
Warning
Warning
