Panasonic AJ-D400, Service Manual

Page: 87 / 104

3-12
1-14. Mode SW Unit Replacement
CHART B
Model Type TYPE A TYPE B TYPE C,D
Connector (A) P22 P2022 P612
P.C.Board (B) MECH
I/F
SERVO SERVO
(Removal)
1. Disconnect the connector (A) on the P.C.Board
(B).
2. Remove the Pinch Solenoid Unit and Loading
Motor Unit. (Refer to item 1-10 and 1-13.)
3. Remove the screw (D) and remove the Mode
Select Switch Unit from Loading Motor Unit as
shown in Figure 1-14.
Note:
Be careful the pin of Mode Switch Unit should be
matched to groove of Main Cam Gear.
(Installation)
1. Install the New Mode Select Switch Unit follow
the removal steps in reverse order (Refer to item
“1-13. Loading Motor Unit Replacement”).
2. After install the Pinch Solenoid Unit, Pinch
Solenoid Position adjustment is required. (Refer
to item 1-11).
Figure 1-14
1-15. Main Cam Gear Replacement
(Removal)
1. Remove the Pinch Solenoid Unit and Loading
Motor Unit. (Refer to item 1-10 and 1-13.)
2. Remove the Main Cam Gear as shown in Figure
1-15.
(Installation)
1. Install the Main Cam Gear, then the pin of Main
Cam Arm Unit (
∗
) should be matched with the
groove position of Main Cam Gear as shown in
Figure 1-15.
2. Follow the removal steps in reverse order.
3. After installation, execute the Pinch Solenoid
Position Adjustment. (Refer to item 1-11)
Figure 1-15