Panasonic AJ-D400, Service Manual

Page: 28 / 104

2-11
3. Mechanical Adjustment Procedure
3-1. Post Height Pre-adjustment
MODE EJECT (POWER OFF)
TOOL VFK1153 (Mech. Neutral Plate)
VFK1154 (Post Height Fixture)
1. Confirm that the Reel Table is located at M-
Cassette position.
2. Install the Mech. Neutral Plate (VFK1153) and
adjust each post height as shown in figure.
3. Adjust the each post to Lower limit by VFK1154
as shown in figure.
4. VFK1149 use for Post height adjustment of S4
and S5 post. VFK1151 use for Post height
adjustment of T3 and T4 post.
Post Limit Post Driver
S5 Post Lower : NOTE VFK1149
S4 Post Lower : NOTE VFK1149
T3 Post Lower VFK1151(2.5mm Nut Driver)
T4 Post Lower VFK1151(2.5mm Nut Driver)
NOTE :
Turn S4 and S5 posts 1 round more counterclockwise
from lower limit.
3-2. Tension Adjustment Flowchart
Lower Limit
Upper Limit
3-3. Tension Offset Adjustment
START
3-4. Neutral Position Adjustment
3-5. Playback Position Adjustment
3-5. Rev Voltage Confirmation
3-6. Tension Spring Adjustment
3-7. Rev Tension Confirmation
END
OK
NG
OK
NG