3-2
(Removal)
1.
Remove the T1 Guide and Cleaning Arm Unit.
(Please refer to item “1-2. Cleaning Arm Unit
Replacement”)
Figure 1-1-1
2.
Unscrew the screw (B) which fix the cable (B) as
shown in Figure 1-1-2.
3.
Remove the flexible cable which connected to
connector (A) on the P.C.Board (B) as shown in
1-1-1.
4.
Unscrew the 3 screws which have spring from the
Cylinder Unit as shown as Figure 1-1-1, then
remove the Cylinder Unit without touching any
mechanical parts as shown in Figure 1-1-2.
Figure 1-1-2
NOTE:
Never touch the cylinder by finger directly, when pull
out the Cylinder Unit.
(Installation)
1.
Install the new Cylinder Unit according to the
opposite procedures to removing.
Figure 1-1-3
NOTE:
When installing the Cylinder Unit, the pin on Mech.
Chassis should match hole of Cylinder Unit as shown
in Figure 1-1-3.
2.
After installing the T1 Guide, T1 Guide Position
Adjustment should be performed.
(Please refer to item “1-2. Cleaning Arm Unit
Replacement” and “1-3. T1 Guide Position
Adjustment”)
1-2. Cleaning Arm Unit
Replacement
(Removal)
1.
Unscrew the 2 screws (A) and remove the T1
Guide as shown in Figure 1-2.
2.
Widen the tip of the cleaner arm, lift up the
cleaning arm unit and remove the spring and
washer.
(Installation)
1.
Install the spring and washer.
Summary of Contents for AJ-D400
Page 17: ...2 1 1 Name of Tape Transportation ...
Page 103: ...3 27 2 3 SERVO P C Board Type C D Model ...
Page 104: ...Printed in Japan F20009912NMH ...