- 28 -
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1
Open the SD card slot cover and insert
(remove) the SD card into (from) the card
slot
B
.
≥
One SD card can be inserted into each of the card slot
1 and the card slot 2.
≥
Face the label side
C
in the direction shown in the
illustration and press it straight in as far as it will go.
≥
Press the center of the SD card and then pull it straight
out.
2
Securely close the SD card slot cover.
≥
Do not touch the terminals on the back of the SD card.
≥
Do not apply strong shocks, bend, or drop the SD card.
≥
Electrical noise, static electricity or the failure of this unit or the SD card may damage or erase the data stored on the
SD card.
≥
When the card access lamp is lit, do not:
j
Remove the SD card
j
Turn the unit off
j
Insert and remove the USB Cable
j
Expose the unit to vibrations or shock
Performing the above while the lamp is on may result in damage to data/SD card or this unit.
≥
Do not expose the terminals of the SD card to water, dirt or dust.
≥
Do not place SD cards in the following areas:
j
In direct sunlight
j
In very dusty or humid areas
j
Near a heater
j
Locations susceptible to significant difference in temperature (condensation can occur.)
j
Where static electricity or electromagnetic waves occur
≥
To protect SD cards, return them to their cases when you are not using them.
≥
About disposing of or giving away the SD card. (
When using an SD card for the first time, it is necessary to format the SD card. (
) When the SD card is
formatted, all of the recorded data is deleted. Once the data is deleted, it cannot be restored.
Access lamp
A
≥
When this unit is accessing the SD card, the
access lamp lights up.
AG-UMR20PJ.EJ(DVQP1321ZA)_E.book 28 ページ ２０１７年５月２２日 月曜日 午後２時１１分
