Panametrics PT878GC, Instruction Manual

Page: 71 / 224

TransPort™ PT878GC User’s Manual 61
Chapter 4.
4.1.9 Entering Analog Inputs
The Analog Inputs option enables you to specify parameters for general purpose or standard volume inputs. To enter
the Analog Inputs option, scroll to the Analog Inputs entry on the Program Menu and press [ENTER] . If you have not
enabled the Standard Volume Option (see page 4-18), the screen appears similar to Figure 58 below. To step through
each parameter, press the [

] key. Refer to Figure A-6 on page A-6 of Appendix A, Menu Maps.
4.1.9.1 Entering General-Purpose Analog Inputs
Figure 58: The Analog Inputs Option Window
1. The first prompt asks you to select whether the desired function is off or general purpose.
a.
Press
[ENTER]
to open the drop-down menu.
b. Scroll to the desired response.
c. Press [ENTER] to confirm your selection.
Note: If you select “Off,” you cannot select any other prompts in this window.
2. The next prompt asks you to create a label for the input. The label corresponds to the measurement type (i.e.,
velocity or temperature), while units symbol corresponds to the measurement units (i.e. feet/sec or degrees F).
a. Press [ENTER] to open the text creation window, which appears similar to Figure 59 below.
Figure 59: The Text Creation Window
Analog Input
Cancel OK
Function
Units
Span
Label
Zero
100
General Purpose
0
Psia
Input A Input B
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 . , “ ‘
= < >
Delete
Cancel
OK