Panametrics DigitalFlow GS868, Programming Manual, Page: 124 / 146

114 DigitalFlow™ GS868 Programming Manual (2-Channel)
D.10 Configuration Utility Setup
The following is an example setup using National Instruments Configuration Utility v3.1.
Figure 40 below shows the Configuration Utility with a flowmeter on the network (Panametrics Flow-XMT).
Figure 40: Configuration Utility Setup Example
Note:
The following procedures assume that the device has been placed in the OOS (out-of-service) mode before
executing.
D.11 Selecting the Desired Measurements
To set the measurement unit for each AI:
1. Double click on the
FLOW
Transducer Block (in the tree under
GEFlow-XMT
).
2. Select the Others tab and open the drop down list for the PRIMARY_SELECTOR and SECONDARY_SELECTOR (refer
to Figure 41 on page 115).
3. Choose the unit from the list (see Figure 41 on page 115).
This unit will correspond to the unit that is available in the AI block for network connection. The
PRIMARY_SELECTOR
unit will correspond to
ANALOG_INPUT_1
and the
SECONDARY_SELECTOR
will correspond to
ANALOG_INPUT_2
.