Panametrics DigitalFlow GS868, Programming Manual, Page: 108 / 146

98 DigitalFlow™ GS868 Programming Manual (2-Channel)
C.5.1 Setting up Ethernet Communications
If you have selected TCP/IP in step 6 on the previous page, the Setup Communications window appears similar to
Figure 20 below.
Figure 20: Setup Communications for TCP/IP
1. Type in the desired
Name and Timeout (in milliseconds).
2. In the IP Address text box, enter the IP address. If the IP address is unknown, run the Device Discovery software util -
ity. All units found will be identified by their MAC address and the assigned IP address. In the
Port Number box,
enter 2101 (the default value).
3. Click [OK] to complete data entry.
IMPORTANT: If you are using Ethernet communications, be sure the GS868 is set up with the default
communications parameters: 9600 baud, no parity, no handshaking, 8 data bits and 1 stop bit. The
port number must match the “Enable Raw TCP access using TCP Port” assignment shown under the
Device Discovery “TCP Server Settings” menu (Configuration>Serial Ports>Port).